The steps for disassembling the LCD splicing screen are as follows:
Turn off the power and disconnect all cables to ensure safety.
Use a screwdriver to remove the screws around the screen, usually on the back of the screen.
Gently remove the screen housing, be careful not to use too much force to avoid damaging the internal parts.
Remove the power cord and data cable on the back of the screen to ensure that the connector is not damaged.
Remove the screen from the bracket, be careful not to touch the surface of the screen to avoid leaving fingerprints or scratches.
If the screen needs to be replaced, install the new screen on the bracket and reconnect the power cord and data cable.
Reinstall the screen housing and tighten the screws.
Reconnect all cables and power, turn on the power, and test whether the screen is working properly.
During the disassembly process, pay attention to the following points:
Operate carefully to avoid damage to the screen and other components.
Mark the position of each connection cable so that it can be connected correctly when reinstalling.
If you are unsure about the operating steps, it is recommended to seek professional help.
